What You Should Do In The Event Of An Electrical Emergency

EZ Eletric
5 min readJun 16, 2023


Electrical issues are typically relatively minor; nonetheless, the circumstances elevate them to the level of becoming an emergency. Because of the potential for significant injury to you and your family, you must take prompt and prudent action if you find yourself in this situation.

Emergencies That Can Occur With Electrical Systems

In most cases, there are four distinct forms of electrical emergencies:

  • Loss of electrical power
  • Electrical Fire
  • Electric Shock
  • Fallen Power Lines

We are going through everything that has to be done in each scenario to keep you safe and assist you in finding a solution to the issue before anything catastrophic takes place. Keep reading.

Power Outage
Often known as blackouts, power failures are the most prevalent kind of emergency. Outages are another name for power failures. Various factors may bring power failures, including a fallen power line, a storm, a lack of energy, etc. These failures can not only be an annoyance, but they can also be quite dangerous. As a result, the following is a list of things that you should do if the power goes out:

Put an end to the primary power source.
Remove the plug from the wall outlet and turn off the main power supply for any heating and cooling equipment powered by the circuit breaker. Be careful to switch off the circuit’s branches before turning off the main circuit breaker. When the power is cut off due to an electrical emergency, you can ensure that all electronics and appliances are safeguarded by using this method.

Verify the Original Source.
A tripped circuit breaker may be the culprit behind the power loss in your house. When an outlet is overloaded, the circuit breakers in the outlet will often trip. Therefore, be sure that there are not an excessive number of appliances connected to a single outlet or extension. If this is the case, you will need to turn off the devices and redistribute the load as soon as the power is restored to prevent the circuit breaker from tripping again.

Examine the Wiring and Breaker for Any Signs of Damage.
If a circuit overload did not cause the power outage, some defective wiring might have caused the problem. Therefore, check to see whether the wire has been worn. If this is not the case, the power loss might have been caused by variations in voltage or a fault with the breaker itself. Calling an Emergency Electrician Riverside should be done only to be safe since resetting the circuit breaker without prior experience might be challenging.

Get in touch with your local distributor.
When you are confident that the issue is on the end of the distributor, give them a call to check and see if they are doing any action to fix the power loss. The power outage might sometimes last for a few hours at a time. Therefore, it is preferable to be prepared.

Reset Safely.
When the power comes back on, you should wait a few minutes before turning on any of your household equipment since the electricity swings might harm them. Be careful to turn on the breaker before doing anything else.

Electrical Fire

Overloading an electrical circuit, having defective or exposed wiring, or placing flammable things next to a light bulb are all potential causes of an electrical fire. In the event of an electrical fire, You should follow the following procedures which Electrical Contractors Riverside follow:

Stop the Flow of Electricity.
If there is a fire caused by electricity, the first thing that one should do is to turn off the power supply where it comes from. To shut the store to your house, you need to turn the switch on the circuit breaker box. It will end the fire promptly and lower the possibility of shocks occurring while you put out the flames.

Put out the fire with the use of a fire extinguisher.
You should only use a fire extinguisher with a Class-C rating if there is a fire involving electrical equipment. You can put out a Class A fire using a fire extinguisher that relies on water, even if the power supply has been shut off. Maintain the rate of chemical dispersion until the blaze has been extinguished entirely.

Send in the Fire Department Immediately.
You should call the fire department immediately, even if you manage to put it out in an electrical fire. If you cannot turn off the power supply at its origin, smouldering things still have the potential to catch fire.

Clear Out of the Area, Please.
If you cannot put out the fire, evacuate the premises as quickly as possible and contact the appropriate authorities. Stop, drop, and roll if your clothing catches fire if it does. Always keep your distance from the ground, and try not to breathe the smoke.

Shocks from the Electricity.
It is possible to come into touch with electricity if electrical wires are frayed, cables are broken, or outlets are left uncontrolled. Regarding the Incident of an Electrical Shock

Put an end to the Power Supply’s operation

As soon as you become aware that someone is being electrocuted, immediately and as fast as you can, switch off the power. In addition, if you are not near the circuit, you should attempt to use an insulated object, such as a wooden rod or a PVC pipe, to break the connection between the electrical source and the person.

Keep your distance from the individual who has just got an electric shock.
Under no circumstances should you touch someone in the presence of electricity if they are directly in contact with it. Keep your cool and move away.

Dial the Number for Your Area’s Emergency Services.
In the event of an electrical emergency, dial 911 for assistance. Meanwhile, you should carry out any CPR or first aid training you may have received. And if you do not have any activity, the operator who answers your call will provide you with the required guidelines to follow until the first responder arrives. Along with the officials you can ask for help from the Electrical Services Riverside.

Fallen Power Lines

A fallen power line poses a significant risk to both human life and property, so deal with it with the utmost care. If you are located near a power line that has fallen, you should take these three steps:

Maintain a Distance of at Least 40 Feet.
Even though no noises, sparks, or lights are coming from a fallen line, it may still be active. Keep at least 40 feet of space between yourself and the power line to prevent accidents. Also, check for any metal fences, fallen branches, puddles, or automobiles that might function as conductive materials and provide an electrical risk.

Make contact with the relevant local authorities. Immediately
If you see a power line hanging or has fallen, you should immediately report it to the local power distributor in charge of these power lines. Also you can connect with the best Riverside Electrical Contractors and they can help you with their skilled teams.

Source: What You Should Do In The Event Of An Electrical Emergency



EZ Eletric

EZ Eletric is a leading electrical services company in California that offers all kinds of solutions for repairs, installations, electrical system enhancements.